How to build your own graffiti wall – A guide step by step
How to build your own graffiti wall - A guide step by step
HOW TO BUILD A WALL FOR GRAFFITI
WOODEN WALL
You will need:
- Screws,
- 4 sheets of plywood 1224 × 2440 × 12 mm
- 3 poles around 3 m high (treated with a coat for outdoor use),
- 4 battens
- 2 bags of dry cement
→ Dig three holes, 45 cm deep with approximately 2,3 m between them from center to center and place the three poles in them.
→ Mix the dry cement and place it around each pole. Cover the last 5 cm with dirt on the top. Make sure the poles are in level when it’s drying. → Attach each batten to the three poles, starting from the bottom, with 60 cm between them in height.
→ Once the battens are up, you can now apply the plywood one at a time. Attach them to the poles 10 cm off the ground. This way, they won’t rot and will last longer.
→ Prime the wall a couple of times before painting your first piece, so it can absorb some paint.
STRETCH FILM WALL
You will need:
- Stretch film 200 m × 50 cm
- Tape
→ Find two poles with 2-6 m between them.
→ Wrap the film around the first pole so it adheres to itself.
→ Stretch the film around the two poles going from the top to bottom, only creating one layer, where each layer over-laps 5 cm.
→ When reaching the last turn, cut the film and fasten it with a piece of tape.
→ Paint the film and remember to take it down and throw it out responsibly once you leave.
These kinds of wall are single use only!
Did you make one of these walls? Show us! Send us your pic to our instagram @graffitibible
Do you want to learn more about graffiti? Check out our online courses HERE
You may also like
Spray Paint Can Tips
Easy graffiti letters
3 Comments
Thanks for your blog, nice to read. Do not stop.
You are welcome!
Reading your article helped me a lot and I agree with you. But I still have some doubts, can you clarify for me? I’ll keep an eye out for your answers.